www.honeywell.com/security
98 | Embedded Network Video Recorder User Guide
Region Configure the event detection region.
1. Click Select. The area selection window opens.
There are 396 (PAL) or 330 (NTSC) small zones.
Green: Indicates the current cursor position.
Grey: Indicates the event detection zone.
Black: Indicates a disarmed zone.
2. Select the event detection area by either clicking and
dragging the mouse or using the direction arrows on the
NVR’s front panel.
Note Use the FN button on the NVR’s front panel to switch
the cursor between selecting and deselecting.
3. Click ENTER on the NVR’s front panel to save the
configuration, or click ESC to exit the area selection
interface without saving the configuration.
Sensitivity Select from 6 levels. Level 6 is the highest sensitivity.
Table 3-23 Motion Detection Configurations
Configuration Description
To Next Page
Loading...