ID2000 Series Installation & Commissioning Manual
Contents
iii 997-433-000-5, Issue 5
May 2010
4.1 EN54 Requirements 18
4.1.1 Loop Devices - Sensors and MCPs 18
4.1.2 Loop Devices - Isolators 18
4.2 Loop Wiring Testing 18
5 Panel Electronics Modules 19
5.1 Introduction 19
5.2 Kit PSU3A 20
5.2.1 Procedure 20
5.3 Dual Transmission Path/Booster Module 23
5.4 Main Chassis 25
5.4.1 main Chassis Configurations 25
5.4.1 Procedure 25
5.5 Extension Chassis 26
5.5.1 Zones 17-80 LED Extension Chassis 26
5.5.2 Extension Chassis (With Printer) 26
5.6 PRN-ID Printer 27
5.6.1 Fitting the Paper Roll 27
5.6.2 Printer Used with Stainless Steel Cover 28
5.7 Display PCB 29
5.8 Base PCB 30
5.8.1 Fitting the Replacement Base PCB 31
5.8.2 Cables and Wiring 31
5.9 Processor PCB 32
5.10 Loop Interface PCB 33
5.10.1Cables and Wiring 33
5.11 Isolated RS232 Interface PCB 34
5.11.1Cables and Wiring 35
5.12 Isolated RS485 Interface PCB 36
5.12.1Cables and Wiring 37
5.13 Label Inserts 37
6 Repeaters and Network 38
6.1 Connecting Repeaters 38
6.2 Network Connections 39
7 VDU 40
8 Commissioning 41
8.1 Introduction 41
8.2 Preliminary Checks 41
To Next Page
Loading...
Need help?
General
