IFS-2600 Installation & Programming Manual Page 29
P/N 10069 ECN08-0066
PROGRAM MODE
Press the following buttons in order shown to enter programming mode.
PREVIOUS
→
NEXT
→
SELECT
→
EXIT
→
ENTER
PROGRAMMING MODE
The liquid crystal display will display all messages and prompts required to program the 2600.
ONLY the "PREVIOUS","NEXT","SELECT","EXIT" AND "ENTER" keys are used in programming mode. All
other keys will give an error beep and are ignored.
Alarm detection is not affected during the programming function but you must exit programming mode if any
other panel functions are to be performed including acknowledge and reset of alarms.
Note: Refer to appendices for detailed explanation of functions
PROGRAMMING HIERARCHY
EXIT
SAVE CHANGES
YES NO
ZONES RELAY
GLOBAL PRINT
ZONES
TYPE OUTPUT
STD LATCHING INDICATE
STANDARD LATCHING AVF I BELL
NON LATCH IB GENERAL
NON LATCH 20S IBG ACF OUT
TIME DELAY 10S IBGA BRIGADE 1
TIME DELAY 20S IBGA BRIGADE 2
TIME DELAY 30S IBGA BRIGADE 1 & 2
TIME DELAY 40S
TIME DELAY 50S
TIME DELAY 60S
To Next Page
Loading...
Need help?
General
