Honeywell NOTIFIER NCD - Display Settings; About Panel Information; System Update Capabilities; User Account Management

24 NCD Instruction Manual — P/N LS10210-051NF-E:C 2/18/2019
Programming Menu Navigation
Display
Tap the DISPLAY touch point to access the back-light brightness setting, wallpaper settings and clean mode.
Brightness Tap and hold the slide touch
point to adjust the back-light brightness.
Setting the display brightness above 75%
for prolonged periods of time will
decrease the overall life of the display.
Clean mode Tap the touch point CLEAN
to activate clean mode. Once activated,
clean mode disables the touch response to
allow for cleaning of the screen. A count-
down timer is displayed providing indica-
tion of time left before the system exits
Clean Mode. The Clean Mode countdown
timer is programmable through VeriFire
Tools and defaulted to 15 seconds. Refer
to the VeriFire Tools for additional infor-
mation.
Wallpaper A Wallpaper image can be
downloaded from VeriFire Tools, to be
displayed on the System Normal screen.
About
Tap the touch point ABOUT to
display the model number, application,
boot version, kernel version, database,
database revision, network, and system
update information.
System Update Tap the touch point
S
YSTEM UPDATE to access application,
kernel, full system, and wallpaper
update capabilities. To update the
application tap the touch point
UPDATE
APPLICATION. To update the kernel tap
the touch point
UPDATE KERNEL. To
update the full system tap the touch
point
UPDATE FULL SYSTEM. To update
the wallpaper tap the touch point
UPDATE WA LL PAP ER . For all updates
the virtual keyboard will appear once
the selected update is tapped on, tap in
the file name to update and then tap the
touch point
PREFORM UPDATE to com-
plete the update. Updates can be done
from a file on a USB drive connected
to the panel.
Users Tap the touch point USERS to
add or remove a user, change the pass-
word for a user account, or recover a
password for a user account.
Figure 3.6 Display Screen
FIRE ALARM
CO ALARM
SUPERVISORY
TROUBLE
DISABLE
OTHER
System Normal
Ack
Silence
Reset
Thu 2/22/18
1:38:06PM
SIGNALS
SILENCED
NOTE: It is recommended to use only a dry clean, lint free/microfiber cloth to clean the display. If additional cleaning is needed, apply a
small amount of Isopropyl alcohol to the cloth and wipe clean. Do not use detergents, solvents, or water for cleaning. Do not spray liquid
directly onto the display.
!
CAUTION: SETTING THE DISPLAY BRIGHTNESS ABOVE 75% FOR PROLONGED PERIODS OF TIME WILL
DECREASE THE OVERALL LIFE OF THE DISPLAY.
Silence
Reset
Tue 01/22/18
02:38:06PM
Master
System Normal
Ack
SIGNALS
SILENCED
OTHER
DISABLE
TROUBLE
SUPERVISORY
CO ALARM
FIRE ALARM
About
Menu - > Settings - > About
NOTIFIER NCD
Unknown
Unknown
Version: 1.000.226 Date: 9/01/2016 Time: 11:12AM
Version: 1.000Date: 9/01/2016 Time: 11:12AM
Model
System Update
Boot
Kernel
Application
Database
Figure 3.7 About Screen