Honeywell NOTIFIER NCD User Manual

NCD Instruction Manual — P/N LS10210-051NF-E:C 2/18/2019 23
Menu Navigation Programming
3.4 Menu Navigation
The MENU touch point is always present and located in the upper left hand corner of the screen. Tap this touch point to bring up the menu
options for settings, programming and test/diagnostics. The
MENU screen navigation is not accessible when there are current
unacknowledged active events. An incoming alarm will automatically exit the
MENU screen to the Events List.
Settings Tap the SETTINGS touch point
to access the settings menu. This menu
provides access to display settings,
brightness clean mode, hardware
version, software version, user
accounts, and about. Refer to section
3.4.1, "Settings"
Programming Tap the PROGRAMMING
touch point to enter the programming
menu. This menu provides access to
network programming. Refer to
“Programming” on page 25.
Custom Actions Only programmable
though VeriFire Tools. Refer to“Custom
Actions” on page 28 as well as VeriFire
Tools.
Test/Diagnostics Tap the
TEST/DIAGNOSTICS touch point to enter
the test/diagnostics menu. This menu
provides access to Lamp Test and CPU
temperature along with panel the
history view.
3.4.1 Settings
Tapping the SETTINGS touch point on the Menu screen will display the Settings options on the NCD.
Display Tap on the DISPLAY touch point to
adjust brightness or enter clean mode.
Refer “Display” on page 24
About Tap the ABOUT touch point to
display information about the panel. Refer
to “About” on page 24
User Accounts Tap the users touch point
to access the user menu Refer to“Users”
on page 24 and “User Login” on page 20
Silence
Reset
Tue 01/22/18
02:38:06PM
Master
System Normal
Ack
SIGNALS
SILENCED
OTHER
DISABLE
TROUBLE
SUPERVISORY
CO ALARM
FIRE ALARM
SETTINGS
PROGRAMMING
TEST/DIAGNOSTICS
CUSTOM ACTIONS
Menu
Clean Mode, Display Brightness, Hardware Versions, Software
Versions, User Accounts
Network Mapping, Node Address
Circuit Board Temperature, CPU Temperature, Lamp Test, History
Custom Actions
Figure 3.4 System Normal Screen
Figure 3.5 Settings Screen
Silence
Reset
Tue 01/22/18
02:38:06PM
Master
System Normal
Ack
SIGNALS
SILENCED
OTHER
DISABLE
TROUBLE
SUPERVISORY
CO ALARM
FIRE ALARM
ABOUT
USER ACCOUNTS
DISPLAY
Settings
Menu - > Settings

Honeywell NOTIFIER NCD Specifications

General

Brand	Honeywell
Model	NOTIFIER NCD
Category	Monitor
Language	English