Honeywell Notifier NFG-8 User Manual

PAGE - 10
NOTIFIER ITALY
Installation and Operation
Manual Doc. M-040.1-NFG8-EN
Rev A.3
NFG-8
NFG-8_manu-inst_ITA
3) SYSTEM START-UP AND OPERATION
This chapter describes the procedures for operating the NFG-8 control unit.
The NFG-8 control unit can be programmed only by means of a Personal Computer with
the appropriate software.
Fig. 3-10) Central front panel
3.1) Ignition
After checking that the system has been installed correctly, the NFG-8 control unit can
be switched on.
At the first power on, after a Warm Up time (3 minutes by default), the display will not
show any indication because at the first power on the control unit requires to be
programmed.
Fig. 3-1) Warm Up Window

Honeywell Notifier NFG-8 Specifications

General

Brand	Honeywell
Model	Notifier NFG-8
Category	Control Unit
Language	English