Honeywell Notifier NFG-8

NFG-8
NFG-8_manu-inst_ITA
Installation and Operation
Manual Doc. M-040.1-NFG8-EN
Rev A.3
PAGE - 11
NOTIFIER ITALY
4.5.2) General settings
Fig. 4.5.2) General settings screen In
"General Settings" you set up
"Heating time": stand by time of the central unit, immediately after the
power on, before being operative
"Slave address": the address of the central unit for communication: DO NOT MODIFY
"Maintenance time" time in which a channel put in Test/Maintenance
remains there before automatically switching to
operating mode.
"Buzzer Reactivation Time" the time that elapses before the buzzer starts again.
to sound, after it has been silenced by an ACK
command.
4.5.3) Channels
The "Channels" menu is used to enable and program the characteristics of the individual
gas detectors in the system.
Overview Channels