OMNI-408/OMNI-408EU Installation and Setup Guide
4–6
TO ARM: Enter any programmed 4-digit user code.
NOTE: The factory default for user 1 is 1234.
The ARMED LED will light and the user may exit through an exit/entry zone for the time period
programmed as the exit delay.
The system can be armed without the backup battery being connected; however, the AC/LB or BAT
light will flash depending on the keypad used.
Keypads will indicate the following message:
Indicator OMNI-LCD/OMNI-LCD-US/XK7LC OMNI-KP/OMNI-KP-US XK108
LED Lit Armed Armed Armed
Display ON: AWAY; EXIT NOW n/a n/a
Arm While Faulted: If programmed (Question 07, Location 2), the user can arm the system while a
delay or interior zone is still faulted.
NOTE:
The Arm While Faulted feature must not be used for UL installations.
STAY ARMING
TO ARM: Press the [STAY] key followed by a 4-digit user code. This will arm the system with all
programmed interior zones excluded.
Indicator OMNI-LCD/OMNI-LCD-US/XK7LC OMNI-KP/OMNI-KP-US XK108
LED Lit Armed Armed Armed, Stay
Display ON: STAY STAY n/a
INSTANT ARMING
TO ARM: Press the [INSTANT] key followed by a 4-digit user code. The INSTANT and ARM LEDs
will light continuously.
Indicator OMNI-LCD/OMNI-LCD-US/XK7LC OMNI-KP/OMNI-KP-US XK108
LED Lit Armed Armed Armed, Instant
Display ON: INSTANT INSTANT n/a
The entire security system (interior and exterior) is armed at this time, eliminating the entry time
delay(s) that have been programmed into the system.
NOTE: The INSTANT mode can be enabled through Programming Question 10, L3.
STAY/INSTANT ARMING
TO ARM: Press the [STAY] key; press the [INSTANT] key, and enter a 4-digit user code.
The STAY/INSTANT mode will arm the system with the characteristics of both the STAY and
INSTANT modes. The keypads will have the ARM, INSTANT, and STAY LEDs ON continuously.
Indicator OMNI-LCD/OMNI-LCD-US/XK7LC OMNI-KP/OMNI-KP-US XK108
LED Lit Armed Armed Armed, Instant, Stay
Display ON: STAY/NS INSTANT, STAY n/a
To Next Page
Loading...
