Honeywell OMNI 408 - SECTION 7 - System Programming; General Information; Programming Questions - Installer Programming

7–1
SECTION 7
System Programming
•••••••••••••••••••••••••••••••••••••••••••
In This Section
♦ General Information
♦ Programming Questions - Installer
Programming
♦ Zone Programming
•••••••••••••••••••••••••••••••••••••••••••
General Information
You can program the system in either of the following methods:
• Directly, through the keypad
• Remotely, using the COMPASS DOWNLOADER
U
L
The Compass Downloader has not been tested for UL applications.
This section describes how to program the system through the keypad. (The COMPASS
DOWNLOADER includes documentation describing its programming procedures.) Keypad
programming is accomplished by understanding the “Programming Questions - Installer Programming”
paragraphs below and completing the Appendix B: OMNI-408 System Programming Worksheet. There
are 50 total programming questions, numbered 01 through 49 and 00.
Within each question, there are several locations labeled L1, L2, etc. for data entry. The system is
shipped from the factory with specific default values, which were selected for a typical installation. If
the default values are suitable for your installation, programming can be simplified. The default values
are listed with each programming question.
Programming Questions - Installer Programming
This section of the manual defines the programming questions along with the values expected for each
question.
DO NOT attempt to enter data before completely filling out Appendix B: OMNI-408 System
Programming Worksheet .