OMNI-408/OMNI-408EU Installation and Setup Guide
9–4
VALUE KEYSTROKES VALUE KEYSTROKES
A [Code] [1] D [Code] [4]
B [Code] [2] E [Code] [5]
C [Code] [3] F [Code] [6]
Example: To enter an A, press the [Code] key followed by the [1] key.
Question Acknowledgment
The keypad chirps on each keystroke. In addition, a beep confirms advancement between question
numbers.
Four beeps signify an invalid input entry. After you make an invalid entry, the system positions you at
the same question number and location as immediately before you made the invalid entry.
Exit System Program Mode
After all programming has been completed, press the [Stay] key to exit the system Program mode.
Data Entry via LCD Keypad
The following paragraphs provide an explanation of how to use an LCD keypad for data entry.
Enter Programming Mode via Keypad
The System Programming mode can be entered ONLY WHILE DISARMED, as follows:
To enter Installer Programming: Press [Code] [*] 4-digit Installer code (default 2468). The keypad
displays:
Installer modes
Enter 1-7
Press [1]. The keypad displays:
Q#01 Edit L01
DATA:XXXX System
The information displayed has the following meanings:
Current
Question
Number
Edit indicates that
you are in Installer
Programming
Current
Location
Number
Q#01 Edit L01
DATA:XXXX System
XXXX = Content of Question or
Location. Blinking character
indicates data that will be
changed by a key entry
Displays System
for system
questions or
ZR401 for RF
questions
To Next Page
Loading...
