EasyManua.ls Logo

Honeywell OMNI 408 - SECTION 5 - Quick Command Modes; Quick Command Mode Listing; Quick Arming [#] [1]; Quick Force Arming [#] [2]

Honeywell OMNI 408
104 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
51
SECTION 5
Quick Command Modes
•••••••••••••••••••••••••••••••••••••••••••
In This Section
Quick Command Mode Listing
Quick Arming
Quick Force Arming
Set Time/Date
Display Zone Directory
Toggle Chime
Toggle Pager
On–Line Download
•••••••••••••••••••••••••••••••••••••••••••
Quick Command Mode Listing
The end user can perform the following commands (if programmed):
COMMAND KEYSTROKES ENABLED IN
Quick Arming [#] [1] Question 07, Location 3
Quick Forced Arming [#] [2] Question 07, Location 3
Set time/date [#] [3] Always enabled
Display zone directory
(LCD keypad only)
[#] [4] Displays all zones enabled. Always enabled.
Toggle chime [#] [6] Always enabled
Display time
(LCD keypad only)
[#] [7] Always enabled
Toggle pager [#] [8] Always enabled
On-line download [#] [9] Question 07, Location 4
Display version [#] [5] [5] Displays the revision level of the system software.
Test keyfobs [#] [5] [6] Mode to test keyfobs for low battery.
Change pager/audio tone
number
[#] [5] [8]
Lets the user modify the current pager/audio tone
phone number to dial.
NOTE: Once the number is changed, pager/audio
tone reports will go to that number until the
number is changed,. again using the #58
command.
U
L
Quick Forced Arming, Toggle Pager, On-line download, Test keyfobs, and Change
pager/audio tone number must not be used for UL installations.
On-line download is not documented in the end user guide because it is only done when the
end user is in communication with someone at the downloading computer.

Table of Contents

Related product manuals