Honeywell OMNI 408 - APPENDIX B OMNI-408 System Programming Worksheet

B–1
APPENDIX B
OMNI-408 System Programming Worksheet
•••••••••••••••••••••••••••••••••••••••••••
Name: ____________________________ Address: _________________________________
Account Number: __________________ Programmed by: ___________________________
Installer Mode Programming
00 INSTALLER CODE
Default: 2468
1 2 3 4
01 PRIMARY TELEPHONE NUMBER
Default: 234AAAAAAAAAAAAA
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
02 SECONDARY TELEPHONE NUMBER or PAGER FOLLOW-ME NUMBER
Default: AAAAAAAAAAAAAAAA
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
03 CALLBACK TELEPHONE NUMBER
Default: AAAAAAAAAAAAAAAA
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
04 ACCOUNT NUMBER 1
Default: 1234
1 2 3 4
05 ACCOUNT NUMBER 2
Default: AAAA
1 2 3 4
06 CS DIALER OPTIONS
Default: E011
1 2 3 4
NOTE: The default value shown above (E011)
applies to the OMNI-408. The default value for
the OMNI-408EU is E031.
07 KEYPAD CONDITIONS
Default: 1004
1 2 3 4
08 SYSTEM TIMEOUTS
Default: 665F
1 2 3 4
09 MISCELLANEOUS SYSTEM OPTIONS
Default: 2C06
1 2 3 4
10 SYSTEM OPTIONS, KEYPAD DISPLAY, ARMING
FEATURES, PAGER EVENTS
Default: 0000
1 2 3 4
11 ZONE 1 TYPE AND CS CODE
Default: 2031
1 2 3 4
12 ZONE 2 TYPE AND CS CODE
Default: 4132
1 2 3 4
13 ZONE 3 TYPE AND CS CODE
Default: 1033
1 2 3 4
14 ZONE 4 TYPE AND CS CODE
Default: 1034
1 2 3 4