Honeywell OMNI 408 - Page 82

OMNI-408/OMNI-408EU Installation and Setup Guide
10–2
Installer Modes
KEYPAD PROGRAMMING: [CODE] + [✱] + Installer Code + [1]
SYSTEM DEFAULT: [CODE] + [✱] + Installer Code + [1], then press [1] +
[3] at the same time
DEFAULT USER CODES: [CODE] + [✱] + Installer Code + [1], then press [7] +
[9] at the same time
READ ONLY MODE: [CODE] + [✱] + Installer Code + [2]
UNATTENDED DOWNLOAD: [CODE] + [✱] + Installer Code + [3]
ON-LINE DOWNLOAD: [CODE] + [✱] + Installer Code + [4]
WALK TEST–REDUCED GAIN MODE: [CODE] + [✱] + Installer Code + [5]
CLEAR TAMPERS: [CODE] + [✱] + Installer Code + [6]
SYSTEM LOG VIEW: [CODE] + [✱] + Installer Code + [7]
NOTE:
• Pressing [STAY] exits installer mode. The system also automatically exits Installer mode if
no keys are pressed for a period of time.