Appendix B — Default Settings
PC42t Desktop Printer User Guide 51
Media Length Sets the length of the printable area measured from
one edge of the label to the edge that is closest to the
printhead. Unit of measurement is defined in the Unit
of Measurement parameter.
1200 dots
Clip Default Determines if the printer prints items outside the
printable area of the label.
When this is set to Off, the printer returns an error if
any part of a bar code label cannot be printed
because that part extends beyond the printable area.
When this is set to On, the printer prints all bar code
labels, but may also print unreadable, incomplete
labels.
Off
Start Adjust Sets the length of media the printer feeds (positive
value) or retracts (negative value) before printing a
label. Unit of measurement is defined in the Unit of
Measure parameter. Range is -9999 to +9999.
0 dots
Stop Adjust Sets the length of media the printer feeds (positive
value) or retracts (negative value) after printing a
label. Unit of measurement is defined in the Unit of
Measure parameter. Range is -9999 to +9999.
0 dots
Media Calibration
Mode
Selects the mode the printer uses to calibrate media.
Use Slow if the printer has trouble identifying gaps or
marks in media
Fast
Media Settings (continued)
Setting Description Default
+RQH\ZHOO
2OG%DLOHV5RDG
)RUW0LOO6&
-EDIA
LENGTH