Web Operation | 59
800-18161V1 - A - 07/2014
IP Address Use the keyboard to enter the corresponding number to modify the
IP Address, and then set the corresponding Subnet Mask and
Default Gateway.
Preferred DNS
Server
Enter the preferred DNS IP address.
Alternate DNS
Server
Enter an alternate DNS IP address.
Enable ARP/Ping
to set IP Address
Service
If you know the camera’s MAC address, then use the ARP/Ping
command to modify or set the camera’s IP address.
Before operating the camera, please ensure that the network
camera and the PC are in the same LAN. This function is On by
default.
To enable ARP/Ping to set the IP address service:
1. Get an IP address. Set the network camera and the PC in the
same LAN.
2. Get the physical address from the label on the network camera.
3. Go to the Run interface, and then enter the following
commands:
arp -s <IP Address> <MAC>
ping -l 480 -t <IP Address>
Such as: arp -s 192.168.0.125 11-40-8c-18-10-11
ping -l 480 -t 192.168.0.125
4. Reboot the camera.
You can see that the setup was successful if you can see that
there is output information such as Reply from
192.168.0.125... from the command output lines.
5. Close the command line.
6. Open the browser and then enter http://<IP address>.
Click Enter, and then you should have access.
Table 3-10 TCI/IP Configuration
Parameter Function
To Next Page
Loading...
Need help?
General