Web Operation | 67
800-18161V1 - A - 07/2014
Note For UPnP on different routers, you must disable the UPnP function.
Enabling UPnP in Windows
If UPnP is enabled in the Windows operating system, then the network can automatically detect
the camera through My Network Places.
1. Go to Start>Control Panel>Add or remove programs.
2. Click to select Add or remove programs, and then select Network Services from the
Windows Components Wizard.
3. Click Details, and then click to select Internet Gateway Device Discovery and Control
client and UPnP User Interface.
4. Click OK to begin the installation.
SNMP
SNMP allows for the communication between the network management work station software
and the proxy for the managed camera. Please install software such as MG MibBrowser 8.0c or
establish SNMP service before you use this function.
Note You must reboot the camera to activate the new setup.
To Next Page
Loading...
Need help?
General