38 EDA5S User Guide
Decode Filter Use these settings to modify or reject data strings.
• Decode filter script
The Decode Filter Script is used to configure a filter for
decode results during scanning. For example, a filter could
be used to reject barcodes that don't begin with certain
characters, remove leading characters (like "00") from the
beginning of a barcode, or only scan barcodes that begin
with certain characters.
• Decode filter timeout (ms)
The decode filter timeout option can be used to disable the
logic inside the filter script after a given amount of time.
• Debug level
Set the filter information level. The default level is 0, no
information. Higher levels emit more information. Level 4
emits the most information.
none
Poor Quality 1D
Reading
Enable this setting when scanning damaged or badly printed
1-D barcodes to improve barcode read success.
Disabled
Video mode Use this setting to specify whether normal or inverse decoding
for linear symbologies is enabled during the execution of
Decode. By default normal video is enabled.
Options include:
•Normal
•Inverse
•Normal and Inverse
Normal
DPM mode Use this setting when scanning Direct Part Marking (DPM)
barcodes that are etched or imprinted directly into the
surfaces of materials including metal and plastic.
Options include:
• No DPM optimization
• Dotpeen DPM decoding
• Reflective DPM decoding
No
optimization
Setting Description Default
To Next Page
Loading...
Need help?
General
Weight and Dimensions
