4 EDA71 User Guide
Charge the Battery Before Use
Before using EDA71, you need to make sure the battery (model number: BAT-
EDA50) is fully charged. You can charge the battery before or after installing it to
EDA71. It will take about 5 hours for the battery to be fully charged using original
charger, quad bay charger, single cradle charger.
Note: Honeywell recommends recommend using Honeywell’s original charger; any
damage caused by use of non-Honeywell charger is not covered by warranty.
Note: Using the computer while charging the battery increases the time required to reach
a full charge.
Replace the Battery
If your battery power is low, you need to either charge the battery in the computer,
or replace it with a charged battery.
To recharge the battery:
1. Save all files and close any open applications.
2. Press and hold the Power button until the options menu appears:
3. Tap Battery Swap. Follow the on-screen instructions to place the unit in battery
swap mode.
Once the tablet is powered off:
Warning: Improper use of the battery in this device can cause fire or
chemical burns. Please do not disassemble the battery or heat
it to 100°C (212°F) and above, or incinerate the battery. Make
sure waste batteries are properly disposed. Keep out of reach
of children.
Warning: Do not store the battery without using for a long period of time.
If storing the battery for over 3 months, please make sure to
check the remaining battery power capacity is at least 30%
every 3 months.
Warning: Ensure all components are dry prior to mating the computers
and batteries with peripheral devices. Mating wet components
may cause damage not covered by the warranty.
To Next Page
Loading...
