3. Installation
3.10. Remote antenna
Revision 1 SmartLine Wireless Temperature and Universal I/O User's Manual 29
Step Action
CAUTION
There may be wires in the wall. Before drilling check that the area is clear of any
obstructions or other hazards.
6
Pull the cable through the hole and form a drip loop on the outside close to where the cable
enters the building. The drip loop should have a radius of at least 12 inches (30 cm).
7
Thoroughly waterproof the lead-in area.
8
Connect the lead-in cable to the SmartLine Transmitter. Tighten cables by hand only; do not
use tools or you could overtighten.
To lightning
arrestor & antenna
12”/30cm
Drip loop
To Next Page
Loading...
