7. Operation
7.2. Transmitter PV display
Revision 1 SmartLine Wireless Temperature and Universal I/O User's Manual 45
7.2 Transmitter PV display
In PV display, the following information is displayed in sequence.
Table 7-2: Transmitter PV display
Item displayed Example Details
PV value 4.7 Latest PV value.
PV engineering units OHMS See Table 7-5.
PV status BAD See Table 7-5. If PV status is not displayed,
then the PV value is good.
Device status LOW BAT See Table 7-5. If multiple device status
messages are in effect, they are displayed one
message per channel until all messages have
been displayed.
If no device status is displayed, then the device
status is normal.
Sensor Status OOS Out of Service
Sensor Channel Status NoChEn No channel enabled
Radio Status RSSI RSSI signal value returned from GXRM radio,
values as per table…
Radio Status RSQI RSQI signal value returned from GXRM radio,
values as per table…
PV Channel CHAN # Channel number, followed by PV
PV Unit DEG C PV temperature units in Celsius
PV Unit DEG F PV temperature units in Fahrenheit
PV Unit PERCENT % of range setting
PV Unit mV Milli Volt, voltage measurement
PV Unit mA Milly Amps, current measurement
Diagnostic information OVR TEMP Over Temperature diagnostic detail
Diagnostic information OVR LOAD Over Load diagnostic detail
Diagnostic information SNSR ERR Sensor diagnostic status reported on LCD
Diagnostic information INPT BAD Input Status diagnostic status reported on LCD
Calibration Information CAL ERR Calibration Error
Calibration Information FACT ERR Factroy Error
PV Limit LIMIT LO PV Status below limit low
PV Limit LIMIT HI PV Status below limit High
To Next Page
Loading...
