8. Maintenance/Repair
8.1. Introduction
Revision 1 SmartLine Wireless Temperature and Universal I/O User's Manual 59
8. Maintenance/Repair
8.1 Introduction
This section provides information about firmware upgrade, preventive maintenance routines and
replacing damaged parts. The topics covered in this section are:
• Replacement of damaged parts such as the transmitter display/sensor and batteries.
8.2 Transmitter Firmware upgrade
The SmartLine Wireless Temperature/UIO Transmitter allows firmware to be updated Over The
Air (OTA). Follow standard OTA firmware update procedure as documented in the OW and
WDM product manuals.
Ensure that DD files are updated once a transmitter is provisioned to the the
OW network or after each FW upgrade. Individual DD files are required to be
installed for each transmitter type.
8.3 Preventive maintenance
The SmartLine Wireless Temperature/UIO Transmitter itself does not require any specific
maintenance routine at regularly scheduled intervals. Maintenace is limited to ensuring the
connections, seals and mounting are tight and secure. There are no moving parts or adjustments
and hence no reason to open the field housing except to inspect for corrosion or conductive dust
entry which could later affect reliable operation. Maintenance is limited to ensuring that
connections, seals and mounting are tight and secure. There are no moving parts or adjustments
and hence no reason to open the field housing except to inspect for corrosion or conductive dust
entry which could later affect reliable operation.
To Next Page
Loading...
Need help?
General
