4.1 Mounting ST 3000 Transmitter, Continued
Bracket mounting,
continued
Table 8 Mounting ST 3000 Transmitter to a Bracket, continued
Step Action
4
Loosen set screw on outside neck of transmitter one full turn. Rotate
Transmitter housing in maximum of 180 degree increment in left or
right direction from center to position you require and tighten set
screw (1.46 to 1.68 Nùm/13 to 15 lb-in).
Example - Rotating Transmitter housing.
Set Screw
Electronics
Housing
180 degrees
max.
180 degrees
max.
ATTENTION
The metric socket head wrench kit supplied with the
SFC includes 2.5, 3, and 4mm size wrenches. You will need the
4mm size wrench for the outside set screw.
Continued on next page
26 ST 3000 Release 300 Installation Guide 2/05
To Next Page
Loading...
