19
FINAL OPERATIONS
Closing the Terminal
To close the terminal, follow these steps:
1. Check that the fitting is positioned correctly.
2. Close the terminal by rotating its cover.
3. Use the two special lateral screws to secure the cover (see
Figure 13). This operation requires a TORX anti-tamper
T10 screwdriver.
4. Insert the small plastic plugs over the special screws.
Fasten the
Torx screws (2)
Figure 13 - Closing the Terminal
Commissioning tips
Commissioning of the device is outside the scope of this manual,
never the less we will include here some tips on this activity
addressing you to the EBI documentation for the full details:
EBI - Temaline Access Control Configuration Guide
Configuring the TemaServers
Factory default IP Address
A device from factory is configured with this default IP address:
To Next Page
Loading...
