Honeywell Tuxedo Touch WIFI - User System Setup; User Setup

26
User System Setup
User Setup provides access to Add a User, Delete a User, and Edit a User.
User Code Setup
Each user must be assigned a name with a corresponding 4-digit user code in order to gain access to
various features and functions. The keypad can hold the identity for 10 Users in its memory. If
additional Users are needed, define the additional Users using the Console Emulation Mode.
Users for the system are programmed in a central user setup location that provides the specific
questions for authorization levels assigned to different users. You may want these users to be the
same, but there are situations in which you may want a user to have limited capabilities. These
capabilities are defined by the Authority Level assigned to each user.
Authority Levels
Authority levels define the system functions a particular user can perform. Depending on the authority
assigned to you, there are certain system functions you may be prohibited from performing. The
following information describes the authority levels available in the keypad and provides the
equivalent authority level name found in your alarm system manuals. The authority levels available in
the keypad are as follows:
Keypad
Authority
Level
Functions
Equivalent System Name
Residential
Systems
Commercial
Systems
Installer Can perform all security functions except can only disarm if
code was used to arm, can change Master Code, cannot
change other user codes, can access the Central Station
Screen options
Note: This authority level cannot be assigned using the keypad.
Installer Installer
Master Can perform all security functions, add/delete users in assigned
partition, program scheduled events, and change partition
master code.
Partition Master Level 1 Master
Normal Perform security functions (arm, disarm) Standard User Level 3
Operator A
Guest Can arm the system in assigned partitions, but cannot disarm
the system unless the system was armed with this code.
Note: Do not assign this level if Quick Arm is enabled in the
system.
Guest Level 4
Operator B
No Access Used to restrict access to a partition. N/A N/A
Note: The authorized code for deleting, adding, and editing users is dependent upon the alarm panel you
are interfacing with. Check your alarm panel Installation and Setup Guide to determine who can delete, add,
and edit users.
User Setup
How to Add a User
To add a user, from the "Home" screen press the Setup icon, and do the following:
ICON ACTION NOTES
1. From the "Home" screen, press the Setup
icon.
2. Press the System Setup icon.