33
Automation
The Automation feature allows access to Group Setup, Scene Setup, Z-Wave Setup and Output List.
WARNING: Automation is intended for lifestyle convenience. Do not use automation for life safety and
property protection.
U
L
• Automation functionality is supplementary only and has not been evaluated by UL.
• Z-Wave applications have not been evaluated by UL.
Enroll/Adding Z-Wave Devices
Before a device will work in the home control network, it must be “Enrolled” (added) into the network.
Each device must be installed according to the manufacturer’s instructions. View the “Programming of
Z-Wave Devices” training video and follow the instructions below to add and control devices in a home
control network.
U
L
Access control functionality has not been evaluated by UL and may not be used in UL Listed
applications.
Enroll/Add a Light Module, Switch or Outlet Module
To enroll a Z-Wave Light, Switch or Outlet module, do the following:
ICON ACTION NOTES
1. At the Tuxedo Touch Keypad:
a) Press the Automation icon from the
“Home” screen and then press the
Z-Wave Setup icon to display the
“Z-Wave Device Management” screen.
b) P
ress the Z-Wave Enroll/Add icon.
2. At the device Module:
a) Press the Function Key on the device.
The keypad displays a series of messages:
“Start add device.
Please press function key on device”
“Adding Controller Unit” “Adding Slave Unit”
“Device added successfully”
Note: Z-Wave light modules may vary; follow
the instructions in the User Guide for your
specific device to enroll properly.
• If a dimmer module was added, an On/Off
button and a slide bar (to control the dimmer)
are displayed.
• If an on/off light, appliance, switch or outlet
module was added, an On/Off button (to
control the device) is displayed.
Z-Wave Device Management Icons
Enroll/Add
Delete
Abort
Remove
Failed
Edit
Reset Default
Router
Security
Link
To Next Page
Loading...
