Automation (cont’d)
41
Remote Services
The Tuxedo Touch™ WiFi supports Remote Services for controlling Z-Wave devices and scenes remotely
from an associated Total Connect account.
The following describes the related features:
• Tuxedo Touch WiFi [automation] can be controlled from a smart phone, i-Pad
TM
, Android
TM
Tablet,
Blackberry
®
or PC using Total Connect and includes webpage support for iOS6 and Google-TV
• Automation scenes can be created in both Total Connect and Tuxedo Touch WiFi
(Scenes created in Total Connect can be edited only via Total Connect)
• Scenes created in Total Connect can be viewed from either Total Connect or directly from Tuxedo
Touch WiFi using the Remote selection on the Tuxedo Touch WiFi scenes page
• Scenes created in Tuxedo Touch WiFi cannot
be viewed from Total Connect.
NOTE: It is assumed that Z-Wave
®
devices have already been enrolled in Tuxedo. If not, refer to the
Automation section in the Installation Instructions for details on enrolling Z-Wave devices and
creating scenes. It is also assumed the installer has an AlarmNet Direct account and is familiar
with Total Connect. If not, contact an AlarmNet representative to open an account.
The following table summarizes the relationships between Total Connect scenes and Tuxedo scenes:
Controlling
Device
Scenes created in Total Conn
Total Connect yes yes no no
Tuxedo yes no yes yes
Note: For troubleshooting purposes, Total Connect server information (including IP addresses) can be
viewed on the Total Connect Server Setup screen by pressing the TC Server Info button (see next page).
Remote Services Setup
NOTE: If used for Remote Services, Tuxedo Touch WiFi should not be configured as a secondary controller.
To use Remote Service, do the following:
1. Verify the Tuxedo is connected to the Internet via WiFi or its Ethernet connector.
2. Enable AlarmNet Direct, enroll the communication device and Tuxedo keypad, and enable Total
Connect usage. The screen displays “using Tuxedo Automation Module” (Yes /No); select Yes.
You will need the Tuxedo keypad’s MAC ID and CRC number, which can be found on a label on the
back of the Tuxedo keypad or on its carton.
Note: Only the Primary keypad (if there is more than one in the same installation) can be enrolled into
Total Connect.
3. Open a Total Connect account for the user if an account does not already exist.
4. After a Total Connect account has been set up, the Tuxedo Keypad must be reset (powered down and
powered up).
5. Enable automation devices to be controlled by Total Connect. See section “Enabling Devices for Total
Connect“. After devices have been enabled for Total Connect, follow the Total Connect prompts to
synchronize the data with Tuxedo. Syncing is required before the enabled devices will display in
Total Connect.
To Next Page
Loading...
