Honeywell Tuxedo Touch WIFI - Enroll a Door Lock Device (Entry Control); Enroll a Honeywell Thermostat

Automation (cont’d)
34
Enroll a Door Lock Device (Entry Control)
Assemble the Z-Wave door lock. NOTE: Be sure the door lock orientation/handedness is correct.
Refer to the Door Lock’s Instruction Guide and connect necessary cables, then install batteries. Enroll the
door lock within 5 feet of the keypad refer to the Door Lock’s Instruction Guide for enrollment procedure.
NOTE: Program the user code in the control panel prior to programming that user code into the door
lock. User Codes must be 4-digits.
Enroll a door lock device as follows:
ICON ACTION NOTES
1. At the Tuxedo Touch Keypad:
a) Press the
Automation icon from the
“Home” screen and then press the
Z-Wave Setup icon to display the
“Z-Wave Device Management” screen.
b) Press the Z-Wave Enroll/Add icon.
2. At the door lock:
a) Program the selected user code from the
panel; refer to Door Lock User Guide.
Note:
Door lock devices may vary; follow the
instructions in the Users Guide for your specific
door lock to enroll properly and to program a new
user code.
The keypad displays a series of messages:
“Please press * function key on device”
“Adding to Security Network”
“Device added successfully”
* Enrollment procedure may vary depending on the
door lock device. Refer to the door lock instructions
for enrollment procedure.
Note: If software is upgraded on the Tuxedo Touch
keypad, enroll the door lock again and re-set the
user code in the door lock.
Enroll a Honeywell Thermostat
Install a Honeywell Thermostat according to the manufactures instructions. Device should be mounted
in the final location and tested before adding it to the system.
To enroll a Honeywell Thermostat into a Z-Wave network, do the following:
ICON ACTION NOTES
1. At the Tuxedo Touch Keypad:
a) Press the Automation icon from the
“Home” screen and then press the
Z-Wave Setup icon to display the
“Z-Wave Device Management” screen.
b) Press the Z-Wave Enroll/Add icon.
2. At the Z-Wave thermostat:
a) Select Thermostat; set the Time and
Date.
b) Follow the instructions in the
thermostat Installation Guide for
“Z-Wave inclusion”.
c) To complete inclusion, press Done.
d) Press Exit on the thermostat to return
to normal operation.
3. At the Tuxedo Touch Keypad:
a) To verify activation, press the Back
icon and wait 30 seconds.
Note: If installing another brand of thermostat,
follow the instructions in the Users Guide for that
specific thermostat to enroll properly.
Some thermostats do not update temperature
status automatically (i.e., Wayne Dalton).
IMPORTANT: Honeywell is not responsible for
property damages due to improper setting of the
thermostat modes.
The keypad displays a series of messages:
“Please press *function key on device”
“Adding Controller Unit”
“Adding Slave Unit”
“Device added successfully”
* If not using a Honeywell thermostat, enrollment
procedure may vary. Refer to the thermostat
instructions for enrollment procedure.
Press the Refresh icon; the device is displayed.