Honeywell VISTA-128BPT - Wiring Burglary, Panic and Smoke Detector Devices to Zones 1-9; Figure 3-8: Telephone Line Connections; Figure 3-9: Wiring Connections for Zones 1-8

VISTA-128BPT/VISTA-250BPT Installation and Setup Guide
3-8
TERMINALS
ON CONTROL
EARTH GROUND
INCOMING TELCO LINE
Handset
TIP RING
RJ31X
JACK
PLUG
DIRECT
CONNECT
CORD
TIP
RING
GROUND
PREMISES
PHONES
{
{
BROWN (TIP) GREY (RING)
GREEN (TIP) RED (RING)
26 27 28 29 30
Incoming
Telco Line
Figure 3-8: Telephone Line Connections
Wiring Burglary, Panic and Smoke Detector Devices to Zones 1-9
The maximum zone resistance is 100 ohms for zones 1 and 8, and 300 ohms for all other zones (excluding the
2K EOL resistor).
U
LC
Smoke detector devices have not been evaluated for ULC installations.
To wire burglary and panic devices to zones 1-9, connect sensors/contacts to the hardwire zone terminals (10 through
23). See Figure 3-9. Connect N.C. and N.O. devices as follows:
• Connect N.C. devices in series with the high (+) side of the loop. The 2K EOL resistor must be connected in series
with the devices, following the last device.
• Connect N.O. devices in parallel (across) the loop. The 2K EOL resistor must be connected across the loop wires
at the last device.
+ +
-
N.C.
N.C.
N.O.
2k EOLR

2k EOLR

+ -
+ +
-
N.C.
N.C.
2k EOLR

2k EOLR

+ +
-
N.C.
+
+
-
N.C.
N.C.
2k EOLR

SMOKE
Zone resistance (Excluding EOLR):
ZONE 1,8: 100 OHMS MAXIMUM
ALL OTHER ZONES: 300 OHMS MAXIMUM
ZONE 1
ZONE 2 ZONE 3 ZONE 4 ZONE 5 ZONE 6 ZONE 7 ZONE 8 ZONE 9
2-WIRE SMOKE DETECTOR LOOP
(Also supports NO/NC Burg contacts)
10 11 12 13 14 15 16 17 18 19 20 21 22 23
N.C.
N.O.
N.O. N.O.
2k EOLR

N.O. N.O.
N.O.
N.C.
N.O.
2k EOLR

2k EOLR

N.C.
Fire
Usage
Burg.
Usage
Red Jumper


Zone response time:
ZONES 1-9: 350mSec-500mSec



hw-zones-002-V1
Figure 3-9: Wiring Connections for Zones 1-8