Honeywell VISTA-128BPT - Programming for ECP Communicator

Section 4 – Programming
4-9
Step Action
1 Enter Output Programming in the #93 Menu
Mode.
2 Program all the information for the relay.
3 Select the output type: ECP (1) (4204).
See Output Programming in the Programming Guide
for a detailed explanation.
Using the VISTA-128BPT/VISTA-250BPT for
Stand-Alone Access Control
The VISTA-128BPT/VISTA-250BPT can be used for
access control without interfacing to VistaKey. A user
can trigger an access point (i.e., door strike) for 2
seconds by entering User Code + [0]. To program the
VISTA-128BPT/VISTA-250BPT for Stand-Alone access
control, perform the following steps:
Step Action
1 Enter Output Programming in the #93 Menu
Mode.
2 Program the output type as 1, or 2.
3 For type 1, program the ECP address and
relay number.
4 For type 2, program the house and unit codes.
5
Program the relay number in field 1∗76
(partition-specific).
See Output Programming in the Programming Guide
for a detailed explanation.
Programming for ECP Communicator
• Program the Communicator in Device
Programming in the #93 Menu Mode
Programming.
• Field ∗56: Selects the time the panel should wait
before it attempts to send a message to the second
destination.
• Field ∗57: Select the initial reporting destination
for messages.
• Field ∗58: Select events for the primary sub’s ID
• Field ∗59: Select events for the secondary sub’s ID.