1 - 3
2. Connect the appropriate interface cable to the scanner and to the terminal/computer.
Note: For Voyager 1202g-BF, you must use the power supply.
3. Make sure the cables are secured in the wireways in the bottom of the base and that the base sits flat on a horizontal
surface.
4. Turn the terminal/computer power back on. The scanner beeps.
5. Verify the scanner or base operation by scanning a bar code from the Sample Symbols in the back of this manual. The
scanner beeps once.
The unit defaults to an IBM PC AT and compatibles keyboard wedge interface with a USA keyboard. A carriage return (CR)
suffix is added to bar code data.
only if
power
supply is
included
Charge and
Communications Base
Keyboard Wedge
Connection:
To Next Page
Loading...
