Honeywell VOYAGER 1202G BF - Inter-Scan Code Delay

2 - 21
Default = Control + X Mode Off.
Numeric Keypad Mode: Sends numeric characters as if entered from a numeric keypad. Default = Off.
Inter-Scan Code Delay
When your keyboard detects that any key is being pressed, released, or held down, the keyboard sends a packet of infor-
mation known as a “scan code” to your computer. This selection allows you to adjust the delay between scan codes. Set
the length (in milliseconds) for a delay by scanning the bar code below, then setting the delay (from 1-30) by scanning digits
from the Programming Chart, then scanning Save. Default = 0 (800 µs).
Windows Mode Control + X
Mode On
* Control + X Mode Off
DOS Mode Control + X Mode On
Windows Mode Prefix/Suffix Off
Numeric Keypad Mode On
* Numeric Keypad Mode Off
Inter-Scan Code Delay