3 - 16
Scanner Name
You may assign a name to each scanner you are using for identification purposes. The default name is “Voyager.”
Perform the rename operation using either the bar codes on page 3-17, or by sending the serial command :*:BT_NAMname.
where name is the new name for the scanner.
To rename scanners with sequential, numeric names, scan the following bar codes. Scan the Reset code after each name
change and wait for the scanner to relink to the base.
Batch Mode Transmit Delay Medium
(500 ms)
Batch Mode Transmit Delay Long
(1000 ms)
To Next Page
Loading...
