Honeywell VOYAGER 1202G BF - Paging; Paging Mode; Paging Pitch; Scanner Address

3 - 7
Paging
Paging Mode
By default, the paging button on the base pages the scanner associated with that base. If you want the paging button on
your base to be disabled, scan the following Paging Mode Off bar code. When Paging Mode is off, the base will no longer
page the scanner when the button is pressed. The red LED on the base will remain lit to indicate that Paging Mode is off.
(This light will go out when the button is pressed, then back on when it’s released.) Default = Paging Mode On.
Paging Pitch
When you press the Page button on the base, the scanner associated with that base will begin beeping (see Page Button
on page 3-3). You can set the pitch of the paging beep for the scanner by scanning one of the following bar codes. Default
= Low.
Scanner Address
Scan the following bar code to determine the address of the scanner you are using.
External Power Only
* Paging Mode On
Paging Mode Off
* Low (1000 Hz)
Medium (3250 Hz)
High (4200 Hz)
Scanner Address