5 - 1
5
Input/Output Settings
Power Up Beeper
The scanner can be programmed to beep when it’s powered up. Scan the Off bar code(s) if you don’t want a power up beep.
Default = Power Up Beeper On - Scanner.
Note: The Voyager 1202g-BF does not issue a power up beep when the scanner is in the base.
Beep on BEL Character
You may wish to force the scanner to beep upon a command sent from the host. If you scan the following Beep on BEL On bar
code, the scanner will beep every time a BEL character is received from the host. Default = Beep on BEL Off.
Good Read and Error Indicators
Beeper – Good Read
The beeper may be programmed On or Off in response to a good read. Turning this option off, only turns off the beeper
response to a good read indication. All error and menu beeps are still audible. Default = Beeper - Good Read On.
Power Up Beeper Off -
Scanner
* Power Up Beeper On -
Scanner
To Next Page
Loading...
