4 - 8
The sounds are as follows:
Alarm Duration
To set the length of time you want the Out-of-Range alarm to sound, scan the following bar code and then set the time-out
duration (from 0-3000 seconds) by scanning digits on the Programming Chart inside the back cover, then scanning Save.
Default = 1 sec.
Using the Scanner with Bluetooth Devices
The scanner can only be used with the CCB00-010BT-01N-BF base.
Minimizing Bluetooth/ISM Band Network Activity
The following settings can help you customize the relinking behavior of the cordless system to obtain the best compromise
between convenience and low interference.
Note: ISM band refers to the 2.4 to 2.48 GHz frequency band used by wireless networks, cordless phones, and Bluetooth.
Auto Reconnect Mode
Auto Reconnect controls whether or not the scanner automatically begins the relink process when a loss of connection is
detected. When the Auto Reconnect On bar code is scanned, the scanner begins the relink process immediately, without
user intervention. Default = Auto Reconnect On.
Setting Sound
0 3 long beeps, medium pitch
1 3 long beeps, high pitch
To Next Page
Loading...
