Honeywell VOYAGER 1202G BF - Msi Message Length; Plessey Code

8 - 45
MSI Message Length
Scan the bar codes below to change the message length. Refer to Message Length Description (page 8-1) for additional
information. Minimum and Maximum lengths = 1-80. Minimum Default = 3, Maximum Default = 80.
Plessey Code
< Default All Plessey Code Settings >
Plessey Code On/Off
Plessey Check Character
No Check Character indicates that the scanner reads and transmits bar code data with or without a check character.
When Check Character is set to Validate, but Don’t Transmit, the unit only reads Plessey bar codes printed with a check
character, but will not transmit the check character with the scanned data.
When Check Character is set to Validate and Transmit, the scanner only reads Plessey bar codes printed with a check
character, and will transmit this character at the end of the scanned data. Default = No Check Character.
Minimum Message Length
Maximum Message Length
On
* Off
* No Check Character
Validate, but Don’t Transmit
Validate and Transmit