11 - 9
RS232 Handshaking *RTS/CTS Off 232CTS0 2-25
Flow Control, No Timeout 232CTS1 2-26
Character-Based Flow Control, No
Timeout
232CTS7 2-26
Two-Direction Flow Control 232CTS2 2-26
Flow Control with Timeout 232CTS3 2-26
Character-Based Flow Control with
Timeout
232CTS9 2-26
*RTS/CTS Off, RTS Inactive 232CTS10 2-25
RS232 Timeout (Range 1-65535) *1000
ms
232DEL#### 2-26
*XON/XOFF Off 232XON0 2-26
XON/XOFF On 232XON1 2-26
*ACK/NAK Off 232ACK0 2-27
ACK/NAK On 232ACK1 2-27
Communication Timeout
(Range 1-65535) *2000 ms
232DLK##### 2-27
Communication Timeout Beeper - Off HSTTOA0 2-27
*Communication Timeout Beeper - On HSTTOA1 2-27
BEL/CAN Mode On BELCAN1 2-28
*BEL/CAN Mode Off BELCAN0 2-28
RS232 Defaults Reset RS232 Defaults 232DFT 2-28
NCR Modifiers
NCR ACK/NAK *NCR ACK/NAK Off NCRACK0 2-28
NCR ACK/NAK On NCRACK1 2-28
Block Check Character *Transmit NCRBCC1 2-29
Don’t Transmit NCRBCC0 2-29
NCR Prefix/Suffix NCR Prefix NCRPR2## 2-29
NCR Suffix *0D NCRSF2## 2-29
Transmit Prefix/Suffix NCRBCP1 2-29
*Don’t Transmit Prefix/Suffix NCRBCP0 2-29
NCR NOF (Not-on-File) Error On NCRRAZ1 2-30
*Off NCRRAZ0 2-30
Scanner to Bioptic Communication
*Packet Mode Off 232PKT0 2-30
Packet Mode On 232PKT2 2-30
*ACK/NAK Off 232ACK0 2-30
ACK/NAK On 232ACK1 2-30
Communication Timeout
(Range 1-65535) *2000 ms
232DLK##### 2-31
Cordless System Operation (Voyager 1202g)
Note: This section applies only to Voyager 1202g cordless systems. It does not apply to corded scanners.
Base Power Communication Indicator *On :*:BASRED1 3-5
Off :*:BASRED0 3-5
Reset Scanner Reset Scanner RESET_ 3-6
Selection
Setting
* Indicates default
Serial Command
# Indicates a numeric entry
Page
To Next Page
Loading...
