MAN0878-09-EN_XLE_XLT_UserManual
A u g u s t 2 3 , 2 0 1 8 P a g e 118 | 158
An alternate way to select the COM setting is to go to Cscape → Tools → Application Settings
→ Communications → Configure and choose connection method in Add Target.
Figure 15.3 – Cscape: Alternative Connection Method Screenshot
Figure 15.4 – Add Target Screenshot in Cscape
NOTE: These fields, Target Name, Connection Medium, Connected Device, and Connection
Settings, need to be filled for communication configuration if Cscape Connection Wizard was
not used. Refer to Table 15.1.
To Next Page
Loading...
