For Systems With Hospira MedNet
TM
Software
1- 2 430-95597-001 (Rev. 06/05)
The Plum A+ and Plum A+3
Volumetric Infusion Systems are
designed to meet the fluid delivery requirements of today’s
evolving healthcare environments. Both are cassette based
multi-function infusion systems. The Plum A+ allows two lines in
and one line out while the Plum A+3 allows six lines in and three
lines out. Each pump can be used for standard, piggyback, or
concurrent delivery. Delivery modes include:
• Standard Infusions
• Multistep Programming
• Loading Dose
• Dose Calculation
The Plum A+ and Plum A+3 are designed to deliver parenteral,
enteral, or epidural infusions over a broad range of infusion
rates from multiple fluid container types.
Both are designed to be used in most areas of patient care,
including, but not limited to:
Product Description
Each system includes a pumping module (hereafter called the
infuser) and an assortment of disposable IV sets (hereafter
called a set), optional accessories, and this operator’s manual.
The Plum A+ host device contains a Connectivity Engine
peripheral module that provides wired Ethernet and wireless
802.11b local area networking capabilities. This allows the
• General Floor • Labor/Delivery/
Post Partum
• Burn Unit
• Medical/Surgical • OR/Anesthesia • Hemodialysis
• ICU/CCU • Post Op/Recovery • Oncology
• Pediatrics • Cardiac Cath Lab • Mobile Intensive
Care
• Neonatology • Emergency • Nutritional
sec01.fm Page 2 Thursday, June 23, 2005 9:36 AM
To Next Page
Loading...
