Need help?Do you have a question about the Hospira Plum A+ and is the answer not in the manual?
General| Device Type | Infusion Pump |
|---|---|
| Model | Plum A+ |
| Manufacturer | Hospira |
| Display | LCD |
| Flow Rate Accuracy | ±5% |
| Volume To Be Infused (VTBI) | 1 to 9999 mL |
| Operating Temperature | 10°C to 40°C (50°F to 104°F) |
| Infusion Modes | Continuous |
| Power Source | AC Power, Internal Battery |
| Battery Life | 6 hours |
| Flow Rate Range | 0.1 to 999 mL/hr |
| KVO Rate | 1 mL/hr |
| Operating Humidity | 20% to 90% RH non-condensing |
| Power Requirements | 100-240 VAC, 50/60 Hz |
| Alarms | Air-in-line, Occlusion, Low Battery |
| Compatibility | Compatible with Plum Series Administration Sets |
| Fluid Compatibility | Compatible with a wide range of intravenous fluids |
Details the Plum A+ and Plum A+3 infusion systems, their features, and intended use cases.
Specifies who can use the Plum A+ infusion system and the intended applications.
Defines the meaning of WARNING, CAUTION, and NOTE messages to ensure safe operation.
Details safety measures and potential hazards for operating the Plum A+ infusion system.
Illustrates and labels the components of the Plum A+ front panel display and keypad.
Describes the function of the main operating keys: ON/OFF, START, and STOP.
Details the functions of the SILENCE, SELECT, numeric keys, CLEAR, and DECIMAL POINT keys.
Explains the self-testing process performed when the infuser is powered on.
Details the steps for powering on the Plum A+ and the initial self-test sequence.
Guides users through programming a basic delivery rate and VTBI for the Plum A+.
Explains how to program and start a titration delivery on the Plum A+.
Details how to program a Piggyback delivery mode for administering multiple fluids.
Explains how to program a Concurrent delivery mode for simultaneous fluid administration.
Describes Standard, Loading Dose, and Multistep programs, including Dose Calculation capabilities.
Guides the initial setup for Dose Calculation, including Area Selection and Line A programming.
To Next Page
