Customizing Your Ampero Mini
I/O
Set the global input/output levels and modes in the I/O menu.
Adjust the optimal Input Level for the instrument or other input you’re
using. Adjustable range is from -20dB to +20dB. Default is set to 0dB.
No Cab Mode is for connecting to instrument amplifiers without
changing saved presets. Turning this on will bypass the CAB module
for Ampero Mini’s L/R output channels ignoring preset settings. You
can apply different settings on L/R output channels for different
scenarios. Default is set to Off.
USB Audio
Use this menu to set up USB audio settings when using Ampero Mini
as a USB audio interface.
The Rec Mode options allow you to select USB recording input
sources on left (L) and right (R) input channels. The selections for
these are same: dry signal (Dry) and wet signal (Effect).
When recording, adjust the optimal Rec Level and Monitor Level
according to the instrument or other devices you're using.
Rec Level: range: -20dB to +20dB, default: 0dB
Monitor Level: range: -20dB to +6dB, default: 0dB
DES I G N IN S P IRAT I ON
12
EXP / FS
You can connect external footswitches to EXP/FS jack for further
control. This menu allows you to set up the working mode of EXP/FS
jack and the functions of external footswitches.
The menu includes MODE, FS5 TAP, FS6 TAP, BANK SEL MODE.
Select a mode from EXP (connect to expression pedal), Single FS
(single footswitch controller) and Dual FS (dual footswitch controller).
The MODE selection affects available options in this menu:
EXP: all other options are unavailable
Single FS: FS4 TAP is unavailable
Dual FS: all other options are available
FS3 TAP and FS4 TAP can be set up as follows:
CTRL 1/2/3: For controlling module on/off
Looper Rec/Play: Record/play loop phrases
Loop Stop: Stops looper playback
Looper: Enter/exit looper menu
Drum On/Off: Drum rhythm play/stop
Drum: Enter/exit drum menu
Tuner: Enter/exit tuner
Bank+/Bank-: Change banks by toggling up or down
Tap Tempo: Tap tempo function
Patch+/Patch-: Change patches by toggling up or down
FX1~RVB On/Off: Switch modules on/off
Display
This menu setup the display and language of Ampero Mini.
Use DISPLAY MODE to switch two display modes in Main Display
screen. Mode 1 stresses patch number, and Mode 2 stresses patch
name. Default is set to Mode 1.
Use LANGUAGE to switch system language.
Use COLOR to switch between 7 theme colors.
Use DISPLAY TIME to set how long screen display lasts for energy
saving. Selections are Always On, 1min, 5min, 10min, 20min, 30min,
40min, 50min, 60min. Default is set to 30min. After screen display
goes out, any operation on Ampero Mini (incl. touching the
screen/pressing footswitches or exp pedal) will wake up the screen.
About
About will show you information about Ampero Mini’s firmware.
To Next Page
Loading...
Need help?
Digital Audio Specifications
Display
Weight and Dimensions
