CHANGING SETTINGS ON THE SUPERUSER MENU
SERVICE MANUAL 23
3. Set the desired sound properties. For each event, you can specify the following
properties.
Property What it does
Sound Set Used to select the desired sound set for the alarm. The default
sound set is Android.
Sound File Used to select the specific sound from the set. You can then
test the sound by touching the Test Sound button.
Repeat Used to specify for how many times the alarm should be
repeated.
Start repeat delay Used to specify the interval between the first and the second
sounding of the alarm.
End repeat delay Used to specify the interval between the second to last and the
final sounding of the alarm.
End repeat delay
after
Used to specify the interval between the sounding of the alarm
after the first sounding of the alarm.
Start volume Used to specify the volume at the first sounding of the alarm.
End volume Used to specify the volume after the final sounding of the
alarm.
End volume after Used to specify how many times the sound should be repeated
until it reaches the volume specified in End volume.
Start playback rate Used to specify the playback frequency of the first sounding of
the alarm. The interval ranges from 0.5 to 2.0 with intervals of
0.1.
End playback rate Used to specify the playback frequency at the final sounding of
the alarm.
End playback rate
after
Used to specify the playback frequency of the alarm while it is
being repeated.
Test sound Used to test the sound specified in Sound File.
4. Follow the steps above for all events to which you want to assign a sound.
To Next Page
Loading...
