HP 1910 Getting Started Guide

30
BOOT MENU
1. Download application file to flash
2. Select application file to boot
3. Display all files in flash
4. Delete file from flash
5. Modify bootrom password
6. Enter bootrom upgrade menu
7. Skip current configuration file
8. Set bootrom password recovery
9. Set switch startup mode
0. Reboot
Enter your choice(0-9):
Table 7 Boot menu options
Item Descri
p
tion
1. Download application file to flash Download a system software image file to the Flash memory.
2. Select application file to boot Select the system software image file to boot.
3. Display all files in flash Display all files in the Flash memory.
4. Delete file from flash Delete files from the Flash memory.
5. Modify bootrom password Modify the Boot ROM password.
6. Enter bootrom upgrade menu Access the Boot ROM update menu.
7. Skip current configuration file
Start the switch with the factory default configuration. This is a
one-time operation and does not take effect at the next reboot. You
use this option when you forget the console login password.
8. Set bootrom password recovery
Disable or enable the Boot ROM password recovery function. By
default, Boot ROM recovery is enabled. You can disable this function
to protect system security.
9. Set switch startup mode
Set the startup mode to full mode or fast mode, as described in
“Changing the startup mode.”
0. Reboot Restart the switch.
NOTE:
The system by default has no Boot ROM password. HP recommends that you set a Boot ROM password
immediately after you access the Boot menu.
• If you perform no operation or press any key other than Ctrl + B within one second, the system
automatically starts up when the remaining time becomes zero, and displays the following
information:
Starting to get the main application file--flash:/V1910-CMW520-A1101.bin!......
.................................................................
The main application file is self-decompressing................................
...............................................................................
..............................Done!
System is starting...

HP 1910 Specifications

General

Model	HP 1910
Category	Switch
Port Type	10/100/1000BASE-T
Layer	Layer 2
PoE Support	No
MAC Address Table Size	8K entries
VLAN Support	Yes
Management	Web-based GUI
Switching Capacity	56 Gbps
Forwarding Rate	41.7 Mpps
Jumbo Frame Support	Yes
Ports	24