HP 1910 Getting Started Guide

45
LEDs
Table 10 LEDs at a glance
LED Availabilit
y
Power LED Entire series
RPS status LED V1910-24G-PoE (365W)
Port mode LED
1910-8G-PoE+ (65W) , 1910-8G-PoE+ (180W),
V1910-24G-PoE (170W), V1910-24G-PoE (365W)
10/100/1000Base-T Ethernet port LED Entire series
1000Base-X SFP port LED Entire series
Power LED
The power LED shows the operation status of the switch.
Table 11 Power LED description
LED mark Status Description
Power
Steady green The switch is operating properly.
Flashing green (1 Hz)
The system is performing power-on self test (POST) or
downloading software.
Flashing green (3 Hz) POST has failed or another fatal error has been detected.
Off The switch has been powered off.
RPS status LED
The V1910-24G-PoE (365W) has one RPS status LED on its front panel to show the operating status of the
RPS DC input.
Table 12 RPS status LED description
LED mark Status Descri
p
tion
RPS
Steady green The RPS DC input is normal.
Off The RPS unit is not connected or the RPS DC input is abnormal.
Port mode LED
The 1910-8G-PoE+ (65W), 1910-8G-PoE+ (180W), V1910-24G-PoE (170W), and V1910-24G-PoE
(365W) switches have a port mode LED to indicate the type of information that the network port LEDs
(excluding the SFP port LEDs) are showing. You can use the port LED mode switching button to change
the type of displayed port information.

HP 1910 Specifications

General

Model	HP 1910
Category	Switch
Port Type	10/100/1000BASE-T
Layer	Layer 2
PoE Support	No
MAC Address Table Size	8K entries
VLAN Support	Yes
Management	Web-based GUI
Switching Capacity	56 Gbps
Forwarding Rate	41.7 Mpps
Jumbo Frame Support	Yes
Ports	24