44 Configuring a system for the first time
Using the Configuration Wizard
The Configuration Wizard helps you initially configure the system or change system configuration settings.
The wizard has several steps, which are highlighted at the bottom of the panel as you complete them. The
last step prompts you to confirm changes before applying them. If you cancel the wizard, no changes are
made.
To use the wizard, in the Configuration View panel, right-click the system, select Configuration >
Configuration Wizard, and follow the online prompts to specify the basic settings described below. See the
online help for detailed information about the settings.
• Password for default users.
• Network-port configuration.
• System-management services, including the following out-of-band and in-band services:
• Web browser interface, known as SMU (Storage Management Utility).
• Command Line Interface (CLI).
• Storage Management Initiative Specification (SMIS).
• File Transfer Protocol (FTP).
• Simple Network Mgmt Protocol (SNMP).
• Service Interface and Service Debug, both used for technical support only.
• In-band CAPI Capability.
• In-band SES Capability.
If a service is disabled, it cannot be accessed.
• System information, including system name, contact, location, and description.
• Email addresses and three SNMP trap hosts to receive notifications of system events.
• Host-port configuration.
When the configuration task is complete, you will be prompted to provision storage, and the Provisioning
Wizard appears.
To Next Page
Loading...
Need help?
General
