HP 330 Service Information Manual

Figure 2-9. Expander to Computer Attaching Screws
b. Remove the expander from the computer and install the connector's protective
sleeve
or set the expander on its side.
c. Remove the flat-head screw that holds the computer's top cover to the motherboard
connector.
2. Slide the computer's top cover to the rear and lift up on the back of the cover to remove
it.
3. To install the top cover, place the top cover on the chassis, ensuring the RF shield plates
are outside the sides of the chassis.
Assembly Note
When installing the top cover, ensure the lip on the back edge of the
top cover catches the tab on the chassis when the top cover is fully
seated in place.
4. Slide the top cover forward and fit the front of the top cover inside the front cover edges
and engage the lip on both sides at the rear of the cover in the tabs on the chassis.
5. If an expander is to be installed:
a. Replace
the top cover screw.
b. Install
the expander.
c. Replace the two expander attaching screws.
d. Replace
the expander top cover.
42 Assembly Replacement

HP 330 Specifications

General

Storage	500 GB HDD (7200 rpm)
Operating System	Windows 7 Professional 64-bit
Graphics	Intel HD Graphics
Dimensions	14.88 x 6.89 x 15.02 inches
Processors	Intel Celeron, Pentium, Core i3/i5/i7
Processor	Intel Celeron
USB Ports	4x USB 2.0
Optical Drive	DVD-Writer
Network	Gigabit Ethernet