HP 5920

Predefined user roles
network-admin
Usage guidelines
802.1X must be enabled both globally and on the intended port. Otherwise, it does not function.
Examples
# Enable 802.1X globally.
<Sysname> system-view
[Sysname] dot1x
# Enable 802.1X on Ten-GigabitEthernet 1/0/1.
[Sysname] interface ten-gigabitethernet 1/0/1
[Sysname-Ten-GigabitEthernet1/0/1] dot1x
[Sysname-Ten-GigabitEthernet1/0/1] quit
Related commands
display dot1x
dot1x authentication-method
Use dot1x authentication-method to specify an EAP message handling method.
Use undo dot1x authentication-method to restore the default.
Syntax
dot1x authentication-method { chap | eap | pap }
undo dot1x authentication-method
Default
The network access device performs EAP termination and uses CHAP to communicate with the RADIUS
server.
Views
System view
Predefined user roles
network-admin
Parameters
chap: Sets the access device to perform Extensible Authentication Protocol (EAP) termination and use the
Challenge Handshake Authentication Protocol (CHAP) to communicate with the RADIUS server.
eap: Sets the access device to relay EAP packets, and supports any of the EAP authentication methods
to communicate with the RADIUS server.
pap: Sets the access device to perform EAP termination and use the Password Authentication Protocol
(PAP) to communicate with the RADIUS server.
96