HP 5920

Usage guidelines
There can be only one default ISP domain.
The specified ISP domain must already exist.
To delete the ISP domain that is used as the default ISP domain, you must change it to a non-default ISP
domain first by using the undo domain default enable command.
Examples
# Create an ISP domain named test, and configure it as the default ISP domain.
<Sysname> system-view
[Sysname] domain test
[Sysname-isp-test] quit
[Sysname] domain default enable test
Related commands
• display domain
• domain
state (ISP domain view)
Use state to set the status of an ISP domain.
Use undo state to restore the default.
Syntax
state { active | block }
undo state
Default
An ISP domain is in active state.
Views
ISP domain view
Predefined user roles
network-admin
Parameters
active: Places the ISP domain in active state to allow the users in the ISP domain to request network
services.
block: Places the ISP domain in blocked state to prevent users in the ISP domain from requesting network
services.
Usage guidelines
By blocking an ISP domain, you disable offline users of the domain from requesting network services. The
online users are not affected.
21