Usage guidelines
The VPN specified here applies to all servers in the RADIUS scheme for which no VPN is specified.
Examples
# Specify VPN test for RADIUS scheme radius1.
<Sysname> system-view
[Sysname] radius scheme radius1
[Sysname-radius-radius1] vpn-instance test
Related commands
display radius scheme
HWTACACS commands
data-flow-format (HWTACACS scheme view)
Use data-flow-format to set the traffic statistics unit for data flows or data packets.
Use undo data-flow-format to restore the default.
Syntax
data-flow-format { data { byte | giga-byte | kilo-byte | mega-byte } | packet { giga-packet |
kilo-packet | mega-packet | one-packet } } *
undo data-flow-format { data | packet }
Default
Traffic is counted in bytes and packets.
Views
HWTACACS scheme view
Predefined user roles
network-admin
Parameters
data { byte | giga-byte | kilo-byte | mega-byte }: Specifies the unit for data flows, which can be byte,
kilobyte, megabyte, or gigabyte.
packet { giga-packet | kilo-packet | mega-packet | one-packet }: Specifies the unit for data packets,
which can be one-packet, kilo-packet, mega-packet, or giga-packet.
Usage guidelines
The command does not apply to 802.1X and MAC users, for whom the switch does not support traffic
accounting.
The data flow and packet measurement units for traffic statistics must be the same as configured on the
HWTACACS accounting servers. Otherwise, accounting results might be incorrect.
60
To Next Page
Loading...
Need help?
General
