HP 5920

Parameters
seconds: Specifies the NAT keepalive interval in seconds, in the range of 5 to 300.
Usage guidelines
This command takes effect only for a device behind a NAT server. When the device resides behind a
NAT server, the IKE gateway behind the NAT server needs to send NAT keepalive packets to its peer IKE
gateway to keep the NAT session alive. For information about how to display the lifetime of NAT entries,
see Layer 3–IP Services Command Reference.
Examples
# Set the NAT keepalive interval to 5 seconds.
<Sysname> system-view
[Sysname] ike nat-keepalive 5
ike profile
Use ike profile to create an IKE profile and enter IKE profile view.
Use undo ike profile to delete an IKE profile.
Syntax
ike profile profile-name
undo ike profile profile-name
Default
No IKE profile is configured.
Views
System view
Predefined user roles
network-admin
Parameters
profile-name: Specifies an IKE profile name, a case-insensitive string of 1 to 63 characters.
Examples
# Create IKE profile 1 and enter its view.
<Sysname> system-view
[Sysname] ike profile 1
[Sysname-ike-profile-1]
ike proposal
Use ike proposal to create an IKE proposal and enter IKE proposal view.
Use undo ike proposal to delete an IKE proposal.
384